I just wanted to be the first to post something. I'm still fine tuning the offsets to get reliable pointing from horizon to azimuth and 360 degrees. Still not there yet.
I hope this is the right place for this question. I also posted this on the group FB page but this forum is much more organized.
OK, let be straight here, I am not a programmer nor want to be. And if the question has been asked before I apologize in advance and I have read all of the threads in the Automation section.
I'm using the dome rotation kit firmware that came on my unit under ASCOM POTH and have downloaded the Celestron and NexDome drivers only.
There is a "Position Update in X sec" in the POTH window set for 9 seconds. Is there anyway to change this? My dome starts and stops many times when slaved to my mount (kind of sync'd).
I'm thinking if this timer was shorter the dome would move more quickly.
I hope this is the right place for this question. I also posted this on the group FB page but this forum is much more organized.
OK, let be straight here, I am not a programmer nor want to be. And if the question has been asked before I apologize in advance and I have read all of the threads in the Automation section.
I'm using the dome rotation kit firmware that came on my unit under ASCOM POTH and have downloaded the Celestron and NexDome drivers only.
There is a "Position Update in X sec" in the POTH window set for 9 seconds. Is there anyway to change this? My dome starts and stops many times when slaved to my mount (kind of sync'd).
I'm thinking if this timer was shorter the dome would move more quickly.
Thanks, Steven