Hello,
as I am reading, the pre-set range for the shutter is 46000
I checked this with Ardunio Termnial and the shutter reports this value.
But the shutter needs 153000 steps to open fully.
As a second problem: The shutter looses the connection with the rotator when closing. It stops at around half way (I have set a greater range with @RWS, stops at around 110000) Only re-power cycle helps.
I have reset both shutter and rotator to factory defaults as well as updated with firmware.
I am running 4.0 on a 2018 shutter (I never was able to install it until lastweek, so the problem came up only now)
Any help would be appreciated
Thanks
Christian
Sorry, I didn't see this before. What you are describing is something many of us have had happened. Since no one has responded before me, my only suggestion is to contact ND and get some technical help with your Arduino system, which has been replaced by Beaver.
Just to be clear, what I'm getting from your post is the shutter just stops operating and not stalling yet continues to run. If this is correct, call ND as soon as you can. Let Eva know it's technical support you need so she can get a hold of Babak.
If anyone else can help on the forum, please jump in.
Steven