I just finished installing my new Nexdome and I have found that the limit switches for the shutter were wired wrong. Open limit wired to closed on board and the close limit wired to the open on the board. After switching the wires I still have a problem of the shutter overshooting the limits. It makes the small sprockets jump the chain before stopping I need to know how to tune the drive to eliminate this problem. What app to use and what settings to adjust. I had to slow down the shutter to 1/2 its speed and even still some overshoot a cures.
top of page
bottom of page
Lawrence, the following fied my problem.
Open Beaver Dome test and config
Connect to the dome
Go to advanced (scroll all the way to the right)
Enter in the command line
dome sendtoshutter "shutter setsenssizesteps 2"
then press send
then enter
dome sendtoshutter "seletek savefs"
then press send.
You may need to cycle the dome before you try it. If I remember correctly, I had to do it twice.