I have my rotator with the old Arduino board, if I purchase a shutter kit it will come with a Beaver board. Will both work connected to Ascom Device Hub?
David, I'm a little confused at what was news to you. Did you get the new board and make the rotator compatible with the shutter motor? If so, h ow did the retrofit go?
I just spoke to ND, about my cracked dome panels, and mentioned you. Eva told me they got a hold of you and are sending you a replacement board for the rotator. Let us know how that goes.
@Steven Green That is news to me, they certainly didn't tell me. Would be useful as my old box(original type) has become quite noisy, it sounds like a WC refilling, along with other noises
The short answer is NO! The longer answer is contacting ND and have them replace the rotator. It’s going to need a conversation with them, most likely Eva to get Babak involved.
the good news is Beaver is less complicated and I believe the connection between them is batter.
David, I'm a little confused at what was news to you. Did you get the new board and make the rotator compatible with the shutter motor? If so, h ow did the retrofit go?
Steven
I have been waiting some time for a reply to an email and I am not ringing Canada from my mobile in France.
Call them at 1 (604) 421-2835 or email at sales@nexdome.com I know Eva answers the phone.
Steven
Or monitored and responded on this forum, it is after all on their website.
It would be good if they answered emails!
The short answer is NO! The longer answer is contacting ND and have them replace the rotator. It’s going to need a conversation with them, most likely Eva to get Babak involved.
the good news is Beaver is less complicated and I believe the connection between them is batter.
Steven