I’ve installed a Nexdome rotation kit on my 8’ Exploradome. The installation went really well, the stepper has no problems rotating the dome and the software plays nice with SGP. My problem is the sync of the dome slit to the scope, it’s consistently off by roughly 8 degrees on all targets. I’ve remeasured the parameters used in the Ascom hub and even tried adjusting each one to no avail. The home position magnet is set properly and it syncs to home.
How should I go about troubleshooting this problem? Is there one parameter I should be looking at? Any help would be appreciated.
Alex
If you made all the measurement fro the point where the Ra and Dec axis cross it shouldn't make any difference as this is the origin for all calculation :