So my Arduino board had expired. I ordered a DFRduino with XBEE from DFRobot. After I install it do I only need to install the shutter firmware or is more complicated than that?
top of page
To test this feature, visit your live site.
Edited:Â Aug 24, 2023
Dead Arduino Leonardo in Shutter
Dead Arduino Leonardo in Shutter
1 comment
Like
1 Comment
bottom of page
So I installed the Arduino board and did a firmware update from the Nexdome Control software. Received the Firmware update completed successfully message. If I disconnect the USB cable from the shutter then the lights on the Arduino go out. and the manual switch will not work. Plug in the USB and Arduino lights up and the manual switch functions as it should. Looks like the Arduino is not receiving power unless the USB is connected. Battery is at 13.2 volts. Anybody have any suggestions where to start troubleshooting this?