Hello, I may be doing something wrong configuring the Beaver software for dome control. Working through the installation steps, I get to the section where I am enabling the dome to slave the telescope (see pic below). I am supposed to select a pick box for this action to happen (circled in green). However, I am unable to pick the box. The box is unresponsive. What am I doing wrong?
Also, I should note that I have the Beaver drivers in a folder other than the Beaver folder created with the software installation. Not sure if this is related to the problem above, but I thought I would throw it out there anyway.
Thx -Scott
Ahh Right! I had the scope turned on and connected to the PC but did not connect to ASCOM. Anyway, telescope is connected now.
Thanks for your help.
Have you connected to your telescope with ASCOM? That needs to be done before slaving to the scope.