Just began the installation process today. Total progress - zero. After going through the instructions and viewing drawings and photos, I don’t understand how the bays go together. Of course, it would help if` the components were labeled but that is not the major problem.
The holes on the panels just do not line up. Rather than drill new holes, we keep looking for errors on our part. The back panel is a typical issue. I would assume that the back panel is seated inside the side panels but the drawing suggest that they are seated on the inside on the left and on the outside on the right. Photos of completed domes show it done in several different ways. Regardless, the holes at the top of the back panel do not line up with the sides and the top panel. Any suggestions?
It looks like a drill and drill bits are required for the bays. The manual does not properly describe where the holes go either.